Pantographe
TN PTG-01
Stainless Steel pantograph, for copying and scaling line drawings
RATIO RANGE 1 1/8, 1 1/7, 1 1/5, 1 1/4, 1 1/3, 1 1/2, 1 2/3, 2, 2 1/4, 2 1/2 CHA?NE DE RAPPORT 2 3/4, 3, 3 1/2, 4, 5, 6, 7, 8, 10.
HOW TO SET UP. 1. Fix with metal clamp P4 on drawing board 2. Insert tracing point P2 into (B) hole, lead holder P1 into (C) hole and supporter P3 into (E) hole. 3. Place with (A) hole of pantograph onto metal clamp P4. It is ready now. P5 extra leads
HOW TO USE
1. For enlarging drawings: place original under the tracing point
and duplicate under lead holder.
2. For reducing drawings : interchange tracing point with lead
holder position.
3. Remove (F) and (G) screws and reset them for a desired
proportion.